saharadust ha scritto: lun 20 feb 2023, 14:20 Hello. Apologies if this has been raised before, but I wasn't able to find the relevant discussion. I have a CD35x and a CD7550. I'd purchased both remotely and when examining them noticed the following statement on the bottom side (see picture of my 35x).

The message reads somewhat ambiguously... but I think it says remove those screws when transporting. If that is the case, the good news is that someone took care to read the message and do as suggested... The bad news is that no screws were given to me by the sellers.

The question is, should I put screws into these holes and, if so, does anyone know the length and diameter (and any other parameters if relevant)?

Thanks in advance

M.Ambrosini ha scritto: lun 20 feb 2023, 19:56 No even in case of transport if they are packed in a soft way the locking screws are not needed. Don't worry